Product Manual

Quality since 194 6
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone [phone] • Fax [phone]
Toll-Free Fax [phone] • buyersproducts.com
3000689 Rev. B
WARRANTY
Buyers Products Co. warrants all truck/trailer hardware manufac-
tured or distributed by it, to be free from defects in material and
workmanship for a period of one year from date of shipment. Parts
must be properly installed and used under normal conditions. Any
product which has been altered, including modification, misuse,
accident or lack of maintenance will not be considered under
warranty. Normal wear is excluded. The sole responsibility of
Buyers Products Co. under this warranty is limited to repairing or
replacing any part or parts which are returned, prepaid, and are
found to be defective by Buyers Products Co. Authorization from
Buyers Products Co. must be obtained before returning any part.
No charges for transportation or labor performed on Buyers’ prod-
ucts will be allowed under this warranty.
WARNING
Check for locations of brake lines and electrical wiring etc.,
before drilling any holes. Any damage to trailer during
installation is the installer’s sole responsibility.
5. Drill two 1/4" pilot holes in the positions just marked
for the 3/8" lag screws. Be extremely careful not to
drill through the outside trailer wall.
6. Fasten the blower rack to the trailer wall with the
two 3/8" x 2" lag screws and two 3/8” flat washers
supplied.
Bill of Materials
1 3000065 1 Weldment, Blower Rack
2 – 1 Strap, Rubber Tarp 31"
3 – 2 S-Hook, 2-1/2" ZN, Tarp Strap
4 – 6 Washer, Flat 3/8 USS ZN
5 – 2 Screw, HHC 3/8-16 x 2-1/2 Gr. 5 ZP
6 – 1 Screw, HHC 3/8-16 x 2 Gr. 5 ZP
7 – 3 Nut, Nylock 3/8-16 x 7/16 ZN
item part no. qty. description
Enclosed Trailer Installation Instructions
Tools and Materials Required:
•9/16" Wrench or Socket
•Electric Drill
•13/32" & 1/4" Drill Bits
•Hack Saw
•3/4" Plywood Shim Strips
•Shim Screws
1. To maximize floor space in your trailer cut 18" off the
bottom of the blower rack with a hack saw.
2. Drill two 13/32" holes through the center of the
1" square tube at least 12" apart.
3. In order to mount this rack to an enclosed trailer,
you must first add 3/4" plywood shim strips to the
walls. These shim strips must be attached to at least
two wall support studs with suitable fasteners. If you
don’t know what kind or length of fastener to use
contact your trailer dealer or manufacturer for their
recommendation.
4. Hold the blower rack vertical against the shims and
mark the position of the two 13/32" holes.