Product Manual

Quality since 194 6
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone [phone] • Fax [phone]
Toll-Free Fax [phone] • buyersproducts.com
Installation Instructions
—continued on back
WARNING
Check for locations of brake lines and electrical wiring etc.,
before drilling any holes. Any damage to trailer during
installation is the installer’s sole responsibility.
3. Remove the rack from the trailer and use a 13/32" drill
bit to drill two holes in your trailer deck as marked.
4. Assemble the rack to the trailer with two 3/8-16 x
2-1/2" cap screws, four 3/8" flat washers and two 3/8-16
nylock nuts. Do not tighten screws at this time!
CAUTION
Always wear safety glasses when using power tools.
Holds most backpack blowers. Locks with a long
shackle padlock.
STIHL
®
BR-340 and BR-420 owners must use rack part no. LT22.
Important!
Before you begin installing:
1. Read and understand these instructions
completely.
2. Verify that you have received all the parts
listed in the bill of materials.
Bill of Materials
1 3000065 1 Weldment, Blower Rack
2 – 1 Strap, Rubber Tarp 31"
3 – 2 S-Hook, 2-1/2" ZN, Tarp Strap
4 – 2 Washer, Flat 3/8 USS ZN
5 – 2 Screw, Hex Head Lag, 3/8 x 2, ZN
item part no. qty. description
LT20 Backpack Blower Rack
for Utility Landscape Trailers
Utility Trailer Installation Instructions
Tools Required:
•Two 9/16" Wrenches and/or Sockets
•Electric Drill
•13/32" Drill Bit
•Carpenters Square
1. Clamp the blower rack to the trailer side rail with
the base of the upright on the trailer floor. Verify the
rack is square to the trailer deck in both directions
with a carpenter’s square.
2. After determining the position of the rack, mark
center of the two holes in the base on the trailer deck.
5. Clamp the blower rack to the rail of the trailer. Make
sure the rack is square to the rail and the deck of the
trailer with a square.
6. With the rack clamped into position drill a 13/32"
hole through the center of 1" tube and the trailer rail.
7. Fasten rack to the trailer rail with a 3/8-16 x 2" cap
screw, two 3/8" flat washers, and a 3/8-16 nylock nut.
Tighten all three screws at this time.