Specifications

Amplifier Operation - Rear Panel
(From Left to Right)
IEC TYPE POWER CORD RECEPTICAL
Attach one end of power cord here for operation.
FUSE HOLDER (INTEGRATED INTO THE POWER RECEPTICAL)
Fuse for 120v operation:T4AL 250VAC.
A spare fuse is also contained in the fuse holder for your convenience. Pull straight
out after removing power cord. Both the active fuse and the spare fuse are removed.
HARD POWER SWITCH
Removes all AC power from all internal circuits of the amplifier. Set this switch to
the OFF position to consume no power over a long period of time.
LINE IN/OUT
RCA/phono jacks. The Output connector is a wired duplicate of the In connector and
is used as an output to daisy chain multiple amplifiers. The number of units daisy
chained should be limited to 4. If more are used, an audio distribution amplifier should
be used to increase the total possible amplifiers.
SPEAKER LEVEL OUTPUT BINDING POSTS
Used for attaching speaker wire to the ButtKicker
®
Unit(s). NOTE: Please see the
Amplifier Usage Guidelines on page 5 for a list of ButtKicker
®
models that can be
used with this amplifier. Turn the amplifier off before connecting to the Speaker
Output. Wire sizes of 14 gauge and larger are recommended. Binding posts will
accept banana type connectors or bare wire.