Instructions / Assembly

16 Instrucciones de operación LIMPIEZA Y ALMACENAMIENTO
• Limpie la freidora antes del primer uso. • Luego del uso, apague el artefacto, desenchúfelo y déjelo enfriar por 2 horas si está usando agua y por 5
horas si está usando aceite antes de limpiar y almacenar.
• Limpie la tapa, la olla interna y el cesto/las asas con un paño o esponja húmedo usando un detergente
suave. Enjuague y seque exhaustivamente.
• Limpie la carcasa exterior, el cable, el panel de control y el elemento con un paño o esponja húmedo
usando un detergente suave. Seque exhaustivamente. NUNCA coloque estas piezas en un lavaplatos ni las sumerja en agua.
• No coloque el panel de control bajo agua corriente. Si sumerge el panel de control, se puede
electrocutar.
ADVERTENCIA
• Desconecte el cable eléctrico del tomacorriente antes de limpiarlo, de hacerle mantenimiento y/o de
retirar el elemento calefactor. Una descarga eléctrica puede dar como resultado una lesión personal o la muerte.
• No vierta aceite usado en el fregadero. Escurra el aceite de regreso a los contenedores de aceite.
Deseche el aceite usado conforme a las regulaciones locales.
PRECAUCIÓN
17
Troubleshooting
SYMPTOM CAUSE POSSIBLE SOLUTION Power light won’t come on. If none of these solutions work, reset appliance. See RESET FUNCTION on page 12. If appliance still does not work, contact Masterbuilt at 1-800-489-1581.
Appliance not plugged into outlet. Check outlet connection. Breakaway power cord is loose or not connected.
Disconnect and reconnect breakaway power cord.
Control panel is not attached to outer shell correctly.
Remove and reinstall. Make sure control panel is mounted onto the outer shell bracket to engage safety switch.
Circuit breaker tripped. Make sure other appliances are not
operating on the same electrical circuit. Check circuit breakers.
Reset tripped on control panel. See RESET FUNCTION on page 12.
Power light is on but appliance isn’t heating.
Temperature dial has not been set. Appliance will not begin heating
until temperature is set.
Temperature setpoint already reached. Allow appliance to cool below
setpoint or enter higher setpoint.
Appliance takes excessive amount of time to heat up (longer than 1 hr, 15 mins.).
Appliance plugged into extension cord.
Place appliance close to an outlet so an extension cord is not needed.
Lid not in place. Close lid on appliance to retain
heat.
Appliance overheats then shuts off. Temperature sensor malfunctioning,
overheat sensor shutting appliance off.
Contact Masterbuilt at 1-800-489-1581.
No oil or water in pot. Fill pot and reset control panel. See
RESET FUNCTION on page 12.
If symptom is not listed here OR in the Frequently Asked Questions section,
please contact Masterbuilt at 1-800-489-1581.