Specifications

Set the lens at the selected lens opening on the f stop ring. Depress the shutter release

button half way and observe the subject through the

viewfinder. By doing so this will enable you to preview the area of sharpness in the picture

before shooting. In addition Depth of Field viewing can be accomplished by setting the

automatic / manual lever on the lens to the "M" position. By doing so you will preview the

scene without activating the exposure system.

NOTE: MAKE SURE YOU RETURN THE AUTOMATIC / MANUAL LEVER TO THE "A"

POSITION

Depth of Field Scale

The depth of field scale indicates (after focusing) the approximate area that will be sharp in

the picture. Locate on the depth of held scale the corresponding pair of f stop figures. The

distance between these two f stop figures on the focusing ring will be the area of sharpness

in your picture

SELF-TIMER:

This device, when set, trips the shutter release mechanism after a delay of 7-12 seconds. It

is necessary if the photographer wishes to be in the picture and is useful for tripping the

shutter at slow shutter speeds if a cable release is not available.

When using the self-timer the camera must of course be mounted on a tripod or a solid

support of some kind.

To operate, move the self-timer lever counter clockwise as far as it will go. Advance the film

transport lever. Upon pressing the shutter release button, the self-timer mechanism will

start to operate (Fig. 29 - 30).