System information

REMOTE MAINTENANCE 89
To configure the default phone book entry
1
From the Main menu, press F2 to choose
“Call Menu.”
2
Press F3 to choose “Phone Book Menu.”
3
Select “Default” from the Phone Book
menu and press F3.
4
Press PAGE DOWN to move to the COM
port section of the screen.
5
Verify that the number in the “Port” field
is the same as the COM port you speci-
fied during the software installation. To
change the value, press P.
6
To choose the modem speed (baud),
press B until the correct modem speed
appears.
• If you are using a modem, choose
“9,600.”
• If you are using Direct Connect,
choose “19,200.”
7
To move to the modem section, press M.
8
Select the modem type the support
computer uses.
• If your modem is not listed, select
“Hayes Extended.”
• If you are using Direct Connect,
select “Direct Connect.”
Press ENTER.
9
Press F10 to save your changes.
SETTING UP THE SUPPORT COMPUTER’S PHONE BOOK
To create a phone book entry for Lingo
1
From the Main menu, press F2 to choose
“Call Menu.”
2
Press F3 to choose “Phone Book Menu.”
3
Press F1 to begin adding an entry.
4
Type the name for this entry and press
ENTER.
5
Change any information that is specific
to the Lingo site.
6
Press F10 to save your changes.
Note The “Login” and “Password” fields
must be identical to those on Lingo’s phone
book entry. These are set to “support” and
“voice” respectively (all lower case).