System information

60 LINGO TECHNICIAN’S GUIDE
Adjusting tone delay system options
If there is a delay before any of the tones,
you must adjust the appropriate system
option so that Lingo waits before learning
the tone.
After you adjust these system options, you
can initiate the learn call progress tone
tests.
To adjust tone delays
1
Access the technician’s conversation.
2
Select action 5 to change system
options.
3
Enter the three-digit system option
number indicated on the Tone Analysis
Worksheet. The system tells you the
current setting.
4
To confirm that you want to change the
option, press 1 for Yes.
5
Enter the number of seconds of delay
before the tone begins and then
press ✳. The system repeats the value
you have entered.
Conducting the tests to learn call
progress tones
After completing the Tone Analysis Work-
sheet and, if necessary, adjusting the tone
delays, you can initiate the call progress
tone tests. There are two modes: manual
and automatic.
Whether you use the manual mode or
automatic mode, it takes only a few min-
utes and does not require you to exit the
voice messaging system.
Notes
• While the tests are in progress, the voice
messaging system does not answer any
calls. The operator must answer all calls
during the test.
• If you adjust any parameters during the
test, the technician’s conversation allows
you to reset them to the defaults.
LEARNING CALL PROGRESS TONES