Installation Manual

Step 4: Rear Fender Flare Installation (See Photos #14 through #21)
Apply supplied Plastic Tabs along the edge of the
fender, centering the tabs on the marks made in
Step 4. Tabs should be flush to inner edge.
.
16
Slide the supplied “S” Clips over the Plastic Tabs
on the fender lip (6 places).
17
Start supplied Serrated-Flange Screws through
the holes in the flare and into the threaded holes
in the clips. Tighten all screws.
19
Clip Hole locations.
15
Hold the flare in position on fender. Using the
holes in the flare as a guide, mark hole locations
on the fender lip with a grease pencil (6 places).
14
Use an awl if necessary to locate and align holes
in flare and clips.
18