Installation Manual

Slide two supplied “S” Clips over factory holes
located in rear of wheel well as shown.
8
Slide a supplied “U” Clip onto factory hole in
Splash Guard.
9
Hold the flare on the fender. Start a supplied #8
Truss-Head Screw through the lower rear hole in
the flare and into the “U” Clip installed in Step 9.
10
Start supplied Serrated-Flange Screws through
the three upper holes in the flare and into the
threaded holes in the clips. Tighten all screws.
12
Open the door. Insert supplied Tuf-Loks through
existing holes in flare and into holes in fender (2
places).
.
13
Tuf-Loks
Use an awl if necessary to locate and align holes
in flare and clips.
11