Installation Manual

Step 3: Front Flare Installation (See Photos #2 through #12)
2
Starting in the rear of the wheel well, remove
factory fasteners used to attach mud flap (3
places). Discard fasteners.
Open door and remove factory fasteners used to
attach mud flap (2 places). Discard fasteners and
mud flap.
3
Hold the flare in position on fender. Using the
holes in the flare as a guide, mark hole locations
on the fender lip with a grease pencil (3 places).
4
Clip Hole locations.
5
Apply supplied Plastic Tabs along the edge of the
fender, centering the tabs on the marks made in
Step 4. Tabs should be flush to inner edge.
.
6
Slide the supplied “S” Clips over the Plastic Tabs
on the fender lip (3 places).
7