Installation Manual

6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX [phone]
Using fl at end of supplied Edge Trim Tool, seat edge
trim against fl are by inserting straight end between
edge trim and fl are at one end. Next, slide around
entire edge to the other end.
Using supplied Edge Trim Tool, seat edge trim
against vehicle by hooking curved end under edge
trim at one end of fl are. Next, slide around outer
edge of fl are to the other end.
23 24
Front & Rear Edge Trim Tool Procedures
Completed rear fl are installation.
Hold fl are in place while you start six factory screws
using an 8 mm socket wrench. Do not tighten.
Press fi rmly on fl are and tighten all screws.
20 21
22