Installation Manual

6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX [phone]
Install #10 U-Clip in this location. See step 16, 17,
& 18.
Start #8x3/4” Washer Panhead Screw using a
Phillips screwdriver. Do not tighten.
Remove these six factory installed screws using an
8 mm socket wrench. Keep screws for installation of
the rear fl are. X’s indicate a factory screw that will
not be removed.
14
Rear Flare Installation Procedures (Passenger’s Side)
Install #10 U-Clip over 1”x1.5” Black Tab.
Using an awl or similar pointed tool, poke a hole
through 1”x1.5” Black Tab using the #10 U-Clip hole
as a guide.
17
Install 1”x1.5” Black Tab over existing factory hole.
15
16
18 19