Installation Manual

6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX [phone]
2011 Models Only: Remove inner piece at bottom
rear of wheel well.
Install #10 U-Clip at this location. See step 7, 8, 9,
& 10.
Remove four factory installed screws with 8 mm
socket wrench.
Place a pocket 5/16-18x5/8” Nylon Insert Jam Finish
Nut over the end of the screw and tighten, using a
1/2” wrench for the nut and the supplied T-45 torx bit
for the screw.
54
3
Front Flare Installation Procedures (Passenger’s Side)
At location in step 6, there is a lip with two factory
holes. One hole is a circle and one is an oval. The
1”x1.5” Black Tab and #10 U-Clip will be installed
over the oval. The oval is the hole more toward the
front of the vehicle.
6
7