Installation Manual

6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX [phone]
Install #10 U-Clip in this location. See step 15.
Start #8x3/4” Washer Panhead Screw using a
Phillips screwdriver. Do not tighten.
Remove these six factory installed screws using an
8 mm socket wrench. Keep screws for installation of
the rear fl are. X’s indicate a factory screw that will
not be removed.
Install #10 U-Clip over existing hole.
Hold fl are in place while you start six factory screws
using an 8 mm socket wrench. Do not tighten.
13
15
14
16
Rear Flare Installation Procedures (Passenger’s Side)
Press fi rmly on fl are and tighten all screws.
17 18