Installation Manual
6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX 503-283-3007
Install #10 U-Clip over existing factory holes. There
are two holes at the top center location. The hole for
proper installation is the one toward the front of the
vehicle. NOTE: The clip may fi t over the lip loosely.
This can be fi xed by pinching the clip more tightly to
the vehicle.
Hold fl are to the vehicle and start the factory screws
with an 8 mm socket wrench through the factory
holes. Do not tighten.
Press fi rmly on fl are and tighten all screws.
10
Completed front fl are installation.
11
Hold fl are to vehicle and start the kit supplied #8x3/4”
Washer Panhead Screws with a Phillips screwdriver.
Do not tighten.
98
12