Installation Manual

6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX [phone]
2011 Models Only (Optional): If you encounter a fi t
problem, remove inner piece at bottom rear of wheel
well.
Install #10 U-Clips at these locations. See step 7.
Remove three factory installed screws with 8 mm
socket wrench. Save screws for reinstallation.
Place a pocket 5/16-18x5/8” Nylon Insert Jam Finish
Nut over the end of the screw and tighten, using a
1/2” wrench for the nut and the supplied T-45 Torx
Bit for the screw.
This vehicle has two types of front bumper, metal
and plastic. Installation of this fl are is not affected by
which bumper the vehicle has. Pictured here is the
metal bumper.
6
5
3
4
7
Front Flare Installation Procedures (Passenger’s Side)