Installation Manual
Using a Phillips screwdriver, tighten screws
started in step 19. If necessary, use an awl to
locate holes and adjust clips.
21
Using a right-angle drill with a #2 Phillips bit, drill
four supplied Drill Tip Screws through plastic of
fender flare and into sheet metal of fender using the
indents in the flare as a guide.
20
Use a grease pencil to mark two Pinch Weld Clip
locations using the two lower holes in the flare as
a guide.
16
Pinch Weld Clip locations.
17
Pull back each end of flare, and install Pinch
Weld Clips assembled in Step 15, aligning holes
in clips with marks made in Step 17. The snap
lock feature of the clip should be facing outward.
18
Using a Phillips screwdriver, start two supplied
Pan Head Screw into Pinch Weld Clips installed
in Step 18. Do not tighten. Check flare position
and make sure flare fits into style line.
19