Installation Manual

Step 4: Rear Fender Flare Installation (See Photos #10 through #21)
Slide a supplied Washer onto a supplied Torx
Screw.
11
12
Insert one Screw/Washer assembly through
each pocket hole drilled in Step 3.
Place a supplied Nyloc Nut on the backside of
the screw and tighten using a 1/2” socket and
T45 Torx bit.
13
Position flare on fender. Using a right-angle drill
with a #2 Phillips bit, drill two supplied Drill Tip
Screws through plastic of fender flare and into
sheet metal of fender using the indents in the flare
as a guide.
14
15
Assemble Pinch Weld Clip as shown.
Prior to paint, use a drill with 5/16” bit to drill
holes at indents in pockets (10 places). Drill from
inside of parts.
10