Installation Manual
Using a Phillips screwdriver, install a supplied
Pan Head Screw into Pinch Weld Clip installed in
Step 7.
8
5
Assemble Pinch Weld Clip as shown.
Note: Flare will overlap front door when properly
positioned. This overlap does NOT interfere with
either flare fit or door operation. Door hinge points
are located well back of the front seam and the
flareās rear perimeter. The door surface moves in
and away from the flare upon opening.
Install assembled Pinch Weld Clip onto rear
edge of front fender, aligning clip with edge of
fender as shown. The snap lock feature of the
clip should be facing outward.
6
Using a right angle drill with a #2 Philips bit, drill
four supplied drill tip screws through plastic of
fender flare and into sheet metal of fender using
indents in the flare as a guide. Install screws
from front to back.
9
Position flare on fender, pushing flare tightly
against fender. Using a right-angle drill with a #2
Phillips bit, drill one supplied Drill Tip Screw through
plastic of fender flare and into sheet metal of fender
using the indent in the flare as a guide.
7