Installation Manual
FLARE INSTALLATION PROCEDURES
Step 2: Edge Trim Installation (See Illustration #1)
A) Peel two to three inches of red vinyl backing away from edge trim tape.
Applying the adhesive side of the edge trim to the inner side of the flare,
affix the edge trim to the top edge of the flare (the portion that comes in
contact with the vehicle). See Illustration #1
B) Press edge trim into place along the top edge of the flare in one-foot
increments, pulling red vinyl backing free as you continue to work your
way around the top edge of the flare.
Step 3: Front Flare Installation (See Photos #1 through #9)
Slide a supplied Washer onto a supplied Torx
Screw.
2
3
Insert one Screw/Washer assembly through
each pocket hole drilled in Step 3.
Place a supplied Nyloc Nut on the backside of
the screw and tighten using a 1/2” socket and
T45 Torx bit.
4
Illustration #1
Prior to paint, use a drill with 5/16” bit to drill
holes at indents in pockets (8 places). Drill from
inside of parts.
1