Installation Manual
TOOLS FOR EASY INSTALLATION
Right Angle Drill
#2 Phillips Drill Bit
#2 Phillips Screwdriver
Grease Pencil
Awl (optional)
HARDWARE INCLUDED IN KIT:
330” x Edge Trim (Item #1)
38 x Torx Screw (Item #2)
38 x Washer (Item #3)
38 x Nyloc Nut (Item #4)
6 x Pinch Weld Clip Part A (Item #5)
6 x Pinch Weld Clip Part B (Item #6)
22 x Drill Tip Screw (Item #7)
6 x Pan Head Screw (Item #8)
Step 1:
Prior to Installation:
A) Bushwacker only approves installing the flares according to these
written instructions with the hardware provided. WARNING: Failure
to install according to these instructions will invalidate the warranty.
This includes, but is not limited to using alternative installation
methods, hardware, or materials. DO NOT USE: Loctite, SuperGlue,
or similar products on the hardware or the flares.
B) Fit: Verify the fit of the flares to vehicle. (Some filing, sanding, or
cutting may be necessary to ensure proper fit).
C) Painting: (Optional) if paint is desired it must be done prior to
installing flares on the vehicle clean outer surface with a good grade
degreaser. DO NOT USE LACQUER THINNER OR ENAMEL
REDUCER AS A DEGREASER. Wipe outer surface thoroughly with
a tack rag prior to paint.
Paint flares using a high quality enamel, or polyurethane automotive
paint. (Application of a primer coat is optional)
If painting edge trim (not recommended), use a flex additive.
D) Performance: Using larger Tires may increase the area required
to turn the vehicle. Some Tire/Rim combinations may require
lowering bump stops and or installing steering stops to prevent tire
from contacting flare.
E) Exhaust System: Modifications may be necessary to maintain a
minimum 4” clearance between flares and exhaust pipes.
(Exhaust gases should not vent directly onto flares)
F) Metal Protection: All exposed fasteners and bare metal should be
treated with red oxide primer BEFORE installing flares. Spray inner
fender wells with undercoating AFTER flare attachments have been
completed.
G) Decals: If there are any decals on the vehicle in the flare area,
remove them prior to installing flares.
H) Moldings: It may be necessary to trim body side moldings to fit
flares to vehicle. Trace outline of flare on molding using a grease
pencil and cut molding on line using a utility knife. Remove cut
portion (flare will contact bare sheet metal).
Dodge Ram
Set Part # 50908
Rev-4 01/06/10
6710 N. CATLIN AVE. PORTLAND, OR 97203 503-283-4335 1-800-234-8920 (USA AND CANADA) FAX 503-283-3007
Drill Tip
Screw
7.
Pan Head
Screw
8.
Edge Trim
1.
Torx Screw
2.
Washer
3.
Pinch Weld
Clip Part A
5.
Pinch Weld
Clip Part B
6.
Nyloc Nut
4.