Installation Manual

6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX [phone]
20 21
22
Five hole locations to be marked.
Remove the fl are. At the marked locations made in
Step 18, measure inward 22mm from the edge of the
fender. These are the marks to be drilled.
Note: Marks at 22mm may be on either side of the
fi rst mark.
Using a 3/32” drill bit, drill pilot holes at the marks
made in Step 21.
23
Install supplied screws (SW1-0056) into two lower
most holes.
24
Install supplied self-tapping screws (SW1-0066)
into pilot holes in the order indicated. TIGHTEN ALL
SCREWS
1
2
3
5
4