Installation Manual

6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX [phone]
2
1
3
5
4
11
1312
Using a 3/32” drill bit, drill pilot holes at the marks
made in Step 9.
Install self-tapping screws (SW1-0066) into pilot holes
in the order indicated. TIGHTEN ALL SCREWS.
Locate fl are into position on vehicle. Install supplied
screw (SW1-0056) through two bottom rear holes in
fl are and into factory hole in rear of wheel well.
10
Remove the fl are. At the marked location made in
Step 8, measure inward 10mm from the edge of the
fender. These are the marks to be drilled.
Note: Marks at 10mm may be on either side of the
fi rst mark.