Installation Manual

6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX [phone]
Using a T-15 Torx bit, remove two factory screws
in mudguard at rear of front wheel well and remove
mudguard.
Front Flare Installation Procedures (Driver’s Side):
Turn front tire outward for easier installation.
Start supplied Screw (SW1-0056 through two bottom
rear holes in fl are and into factory hole in rear of
wheel well. Do not tighten.
4
Hold front of the fl are fi rmly on the fender. Make sure
front of fl are is aligned with bumper style line. Using
a grease pencil, mark fi ve hole locations using the
holes in the fl are as a guide. See next step.
Style Line
5
7
8 9
Hole locations to be marked.
To mount the fl are into position, hold the fl are 2-3”
inches below the top lip of the wheel well. Push in
and slide up to allow fl are to fully seat against the
wheel well opening.
6