Installation Manual

6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX 503-283-3007

A. Peel two to three inches of red vinyl backing away from Edge

Trim (GP1-0007) tape. Applying the adhesive side of the edge trim

to the inner side of the ﬂ are, afﬁ x the edge trim to the top edge

of the ﬂ are (the portion that comes in contact with the vehicle).

B. Press edge trim into place along the top edge of the ﬂ are in one-foot

increments, pulling red vinyl backing free as you continue to work your

way around the top edge of the ﬂ are.

Put each Bolt/Washer combination through a pocket

hole in the ﬂ are, Bolt head and Washer on the

outside.

Put a Washer (WA1-0012) on each Bolt (SW1-0067).

Place a Nut (NU1-0019) over the end of each Bolt

and tighten, using a 1/2” wrench for the Nut and the

supplied Torx Bit (SW1-0052) for the Bolt. Repeat for

remaining pockets.

Pocket Hardware Installation Procedures:

STEP 2 - EDGE TRIM INSTALLATION

If your ﬂ ares already have the edge trim and pocket hardware installed, skip to Front Flare

Installation Step 4.