Installation Manual

6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX [phone]
Completed rear fl are installation.
Reposition fl are on fender. Check that fl are is
positioned correctly around wheel well. If not, adjust
before tightening screws. Start a supplied screw
(SW1-0058) through the two uppermost holes in the
fl are and into each clip installed in Step 10. Firmly
press the fl are up and toward the vehicle while
tightening both screws.
Start a supplied Screw (SW1-0050) through each
of the remaining holes and into each Clip installed
in Step 16. If needed, use scratch awl (or similar
pointed tool) to locate holes. Tighten all screws.
17
19
18
Press Firmly
Using fl at end of supplied Edge Trim Tool (ET1-0002),
seat edge trim against fl are by inserting straight end
between edge trim and fl are at one end. Next, slide
around entire edge to the other end.
Using supplied Edge Trim Tool (ET1-0002), seat
edge trim against vehicle by hooking curved end
under edge trim at one end of fl are. Next, slide
around outer edge of fl are to the other end.
21
20
Front & Rear Edge Trim Tool Procedures