Installation Manual

6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX [phone]
Tab locations.
Center a supplied Tab (MT1-0014) over the four
marks made in Step 12, aligning edge of Tab with
outside edge of fender lip. Fold around back edge of
fender lip and press fi rmly to adhere.
11
Slide a supplied Clip (CL1-0005) over each Tab.
Clips may need to be adjusted to align with holes
in fl are.
15 16
14
Four marked hole locations.
13
12
Pushing upward on the fl are to ensure proper
positioning, use a grease pencil to mark four hole
locations. Remove screws installed in Step 11 and
remove fl are.
Align fl are on vehicle and start a supplied screw
(SW1-0058) through the two uppermost holes in the
fl are and into each clip installed in Step 10. DO NOT
FULLY TIGHTEN SCREWS AS THEY WILL BE
UNINSTALLED