Installation Manual

6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX 503-283-3007
Position are on fender, aligning bumper piece and
are seams with factory seam. Using a 7mm socket,
reinstall factory screws removed in step 1. If needed,
use a scratch awl (or similar pointed tool) to locate
holes. DO NOT FULLY TIGHTEN SCREWS
5
Check that are is positioned correctly around wheel
well. If not, adjust before tightening screws. Then,
making sure bumper piece and are seams are still
aligned with factory seams, rmly press the are up
and toward the vehicle while tightening all screws.
6
Remove factory mud ap if applicable. Remove
and discard two factory installed plastic retainers
in top (outer) hole locations of sheet metal (ignore
center location). NOTE: Not all vehicles have plastic
retainers installed.
OPTIONAL BUMPER PIECE: Completed front are
installation.
Completed front are installation without bumper
piece.
7 8
Rear Flare Installation Procedures (Drivers Side)
9 10
Center a supplied Clip (CL1-0022) over the two
holes in Step 9. Clips may need to be adjusted to
align with holes in are. Note: The raised collar on
the Clip should face upward into the interior of the
fender.
SEAM
Press rmly