Installation Manual

6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX 503-283-3007

OPTIONAL BUMPER PIECE: Using a 5/16” drill

bit, drill two holes in dimpled hole locations for both

ﬂ are and bumper piece. Note: Holes only need to be

drilled if bumper piece is being used.

OPTIONAL BUMPER PIECE: This vehicle comes

with different bumper sizes. If installing the optional

bumper piece, verify which piece to use by holding

it up to the bumper and making sure it lines up with

factory edges and hole locations. After identifying

bumper piece, apply edge trim along outer surface.

OPTIONAL BUMPER PIECE: Using 3/8” and

7/16” wrenches, attach bumper piece to ﬂ are using

supplied Screw (SW1-0005) and Nut (NU1-0015).

Make sure both pieces are properly aligned before

tightening. NOTE: Do not overtighten or parts will

warp.

Front Flare Installation Procedures (Driver’s Side)

Peel two to three inches of red vinyl backing away from Edge Trim

(GP1-0008) tape. Applying the adhesive side of the edge trim to the

inner side of the ﬂ are, afﬁ x the edge trim to the top edge of the ﬂ are (the

portion that comes in contact with the vehicle).

Press edge trim into place along the top edge of the ﬂ are in one-foot

increments, pulling red vinyl backing free as you continue to work your

way around the top edge of the ﬂ are.

STEP 2 - EDGE TRIM INSTALLATION

OPTIONAL

Plastic Retainer

Remove factory mudﬂ ap if applicable. Using a 7mm

socket, remove four factory screws from wheel

well and save for reinstallation. If installing optional

bumper piece, remove two front factory screws from

bumper and save for reinstallation. Note: Some

models have plastic retainers at top center; remove

with pry tool and discard if on vehicle.