Owners manual

BedRail Caps Installation Procedures:
Peel the red vinyl backing partially away from tape
pads. Note: Make sure the tabs are folded toward the
outside of the part and that the middle tape liner is in
front of the outside liner. See Illustration #1.
Carefully lay the part down on the vehicle bed rail and
position properly. See Illustration #2.
Maintaining part placement, begin by pulling middle
tape tab fi rst. Apply downward pressure to part as you
remove tape liner. Remove carefully. Do not break
tape liner. Repeat for remaining tape liners. Once all
liners are removed, apply fi rm pressure along all taped
areas. Note: 3M™ recommends 30 PSI to promote
full adhesion. Tape reaches maximum adhesive bond
after 24 hours of contact.
Slide a supplied “S” Spring Clip (CL1-0006) onto
the vehicle bed rail in the corresponding fastening
locations on the inside edge of the BedRail Cap. See
Illustration #3.
Fasten the BedRail Cap to the clips with the supplied
Truss Screws (SW1-0050). See Illustration #3.
NOTE: The BedRail Cap is designed with a small
gap at the front of the bed to allow for expansion
and contraction of the part. It is not designed to
cover to the end of the bed. See Illustration #4.
STEP 2 – INSTALLATION
A)
B)
C)
D)
E)
Illustration #1
Illustration #2
Illustration #3 Illustration #4
4325 HAMILTON MILL RD • BUFORD, GA 30518 • 800-241-7219 (USA AND CANADA) • FAX [phone]
2