Owners manual

Overview: Bushwacker only approves installing the BedRail

Caps according to these written instructions with the hardware

provided. WARNING: Failure to install according to these

instructions will invalidate the warranty. This includes, but is

not limited to using alternative installation methods, hardware,

or materials. DO NOT USE: Loctite

, Super Glue

, or similar

products on the BedRail Caps.

Fit: Verify the ﬁ t of the BedRail Caps to vehicle. Note: Trimming

or modiﬁ cations to the BedRail Caps may be necessary for use

with some Truck Bed Covers or Truck Caps.

Preparing the Work Area: Clean the area of installation with a

cloth and rubbing alcohol or prep-solvent to remove any car wax

or dirt from vehicle surface.

Installation Temperature: During installation on the vehicle,

BedRail Caps and tape need to be between 60°F and 110°F

for proper adhesion. Failure to maintain proper installation

temperature may result in the part not functioning correctly. If

not within acceptable range, increase surface temperature using

a heat gun or suitable device (hair dryer) to help reach proper

range. The warmer the vehicle surface, the better the initial

bond, but should not exceed 110° F.

STEP 1 – PRIOR TO INSTALLATION

4 pcs

Ford Smoothback

Ultimate

Set Part # 28511

Rev-1 9/4/2014

• Clean Cloth

• Rubbing Alcohol

• #2 Phillips Screwdriver

• To claim a warranty, you must provide

Proof of Purchase.

LIMITED LIFETIME WARRANTY AGAINST

ANY MANUFACTURING DEFECTS

TOOLS FOR EASY INSTALLATION:

Included in Hardware Kit:

4 pcs

1. 2.

For complete ﬁ tment info visit: www.bushwacker.com

BedRail Caps

4325 HAMILTON MILL RD • BUFORD, GA 30518 • 800-241-7219 (USA AND CANADA) • FAX 800-438-37881

PAGE 1
Ford Smoothback® Ultimate BedRail Caps STEP 1 – PRIOR TO INSTALLATION Set Part # 28511 Rev-1 9/4/2014 For complete fitment info visit: www.bushwacker.com A) Overview: Bushwacker only approves installing the BedRail Caps according to these written instructions with the hardware provided. WARNING: Failure to install according to these instructions will invalidate the warranty. This includes, but is not limited to using alternative installation methods, hardware, or materials.
PAGE 2
BedRail Caps Installation Procedures: STEP 2 – INSTALLATION A) Peel the red vinyl backing partially away from tape pads. Note: Make sure the tabs are folded toward the outside of the part and that the middle tape liner is in front of the outside liner. See Illustration #1. B) Carefully lay the part down on the vehicle bed rail and position properly. See Illustration #2. C) Maintaining part placement, begin by pulling middle tape tab first. Apply downward pressure to part as you remove tape liner.