Installation Manual

6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX [phone]
Remove three factory screws with a 7/32” socket
wrench. Save screws for reinstallation.
4
Front Flare Installation Procedures (Driver’s Side)
Install Clip (CL1-0011) over fender wheel well lip.
See step 6.
5
Place Clip (CL1-0011) over existing factory hole. Line up the holes in the inner piece with the two
uppermost factory holes and the speed clip. NOTE:
Driver’s side inner piece is marked with an “L” and
passenger’s side inner piece is marked with an “R”.
6 7
Place a Nut (NU1-0019) over the end of each Bolt
and tighten, using a 1/2” wrench for the Nut and the
supplied Torx Bit (SW1-0052) for the Bolt. Repeat for
remaining pockets.
3