Installation Manual

Front Side Panel Installation Procedure (Driver’s Side):
4
Toward Front of Vehicle
Toward Rear of Vehicle
5
Peel back roughly 3” of red tape liner from the pieces of tape on the back side of the front part. Make sure red tape
liner will be accessible when part is attached to truck.
Note that there is a strip of tape under the sill plate.
6
Set part in place on vehicle. Remove all red tape liners. Apply FIRM pressure to mounting locations to affix to truck.
Repeat steps 1-6 for passenger side of truck.
Underside of Sill Plate
LUND INTERNATIONAL • 1-800-241-7219