Installation Manual

LUND INTERNATIONAL • 1-800-241-7219
Rear Side Panel Installation Procedure (Driver’s Side):
1
Toward Front of Vehicle
Toward Rear of Vehicle
2
Open vehicle doors. Clean all dirt and debris from vehicle door sills and rocker panel. Use supplied alcohol wipes
where part will attach.
Peel back roughly 3” of red tape liner from the pieces of tape on the back side of rear part. Make sure red tape liner
will be accessible when part is attached to truck.
Note that there is a strip of tape under the sill plate.
3
Set part in place on vehicle. Remove all red tape liners. Apply FIRM pressure to mounting locations to affix to truck.
Underside of Sill Plate