Installation Manual

ManualsBrandsBushwacker ManualsAutomotiveBushwacker 14064 Trail Armor Rocker Panel for Dodge Crew Cab (Black, Pair)

Dodge Ram Trail Armor

Rocker Panel & Sill Plate

Combo Pair

Set Part #14064

BW14064 Rev-1 05-19-2016

For complete fitment info visit : www.bushwacker.com

TOOLS FOR EASY INSTALLATION:

• Cleaning Cloth

STEP 1 - PRIOR TO INSTALLATION

Bushwacker only approves installing the Trail Armor according to

these written instructions with the hardware provided. WARNING:

Failure to install according to these instructions will invalidate the

warranty. This includes, but is not limited to using alternative

installation methods, hardware, or materials. DO NOT USE: Loctite,

SuperGlue, or similar products on the hardware or the flares.

NOTE: Ambient temperature and part temperature must be at

least 60°F (16°C) for proper tape adhesion.

Fit: Verify the fit of the Trail Armor to vehicle. (Some filing, sanding,

or cutting may be necessary to ensure proper fit).

Painting: (Optional) if paint is desired it must be done prior to

installing Trail Armor on vehicle. Clean outer surface with a good

grade degreaser. DO NOT USE LACQUER THINNER OR ENAMEL

REDUCER AS A DEGREASER. Wipe outer surface thoroughly with

a tack rag prior to paint. Application of plastic adhesion promoter for

TPO plastic as per your paint system manufacturer’s

recommendations is required. Paint Trail Armor using a high quality

enamel, or polyurethane automotive paint. If painting edge trim (not

recommended), use a flex additive.

LIMITED LIFETIME WARRANTY AGAINST

ANY MANUFACTURING DEFECTS

• To claim a warranty, you must provide

Proof of Purchase

Included in Hardware Kit:

ALCOHOL

PREP

PAD

8 pcs.

LUND INTERNATIONAL • 1-800-241-7219

Summary of content (3 pages)

PAGE 1
Dodge Ram® Trail Armor ® Rocker Panel & Sill Plate Combo Pair STEP 1 - PRIOR TO INSTALLATION A) Bushwacker only approves installing the Trail Armor according to these written instructions with the hardware provided. WARNING: Failure to install according to these instructions will invalidate the warranty. This includes, but is not limited to using alternative installation methods, hardware, or materials. DO NOT USE: Loctite, SuperGlue, or similar products on the hardware or the flares.
PAGE 2
Rear Side Panel Installation Procedure (Driver’s Side): 1 Toward Rear of Vehicle Toward Front of Vehicle Underside of Sill Plate 2 Open vehicle doors. Clean all dirt and debris from vehicle door sills and rocker panel. Use supplied alcohol wipes where part will attach. Peel back roughly 3” of red tape liner from the pieces of tape on the back side of rear part. Make sure red tape liner will be accessible when part is attached to truck. Note that there is a strip of tape under the sill plate.
PAGE 3
Front Side Panel Installation Procedure (Driver’s Side): 4 Toward Rear of Vehicle Toward Front of Vehicle Underside of Sill Plate 5 Peel back roughly 3” of red tape liner from the pieces of tape on the back side of the front part. Make sure red tape liner will be accessible when part is attached to truck. Note that there is a strip of tape under the sill plate. 6 Set part in place on vehicle. Remove all red tape liners. Apply FIRM pressure to mounting locations to affix to truck.