Installation Manual

Pull tape liner 7 to the left toward the driver side of
the vehicle. NOTE: Refer to steps 8 & 9 for tape liner
tab numbering.
Plug the light connector back into the tail light and
reinstall tail light using a #2 Phillips screwdriver.
1918
6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX [phone]
Pull tape liner 10 downward on a slight diagonal
matching the curvature of the part. NOTE: Refer to
steps 8 & 9 for tape liner tab numbering.
Once all tape liners are peeled, press down on
entire part again applying 30 PSI to the taped areas.
NOTE: The tape reaches maximum adhesive bond
after 24 hours of contact. Do not wash vehicle for
24 hours.
Pull tape liner 8 to the right toward the front of the
vehicle. NOTE: Refer to steps 8 & 9 for tape liner
tab numbering.
Pull tape liner 9 downward. NOTE: Refer to steps 8
& 9 for tape liner tab numbering.
23
21
22
Press down on the part along the length where tape
strip 7 is.
20