Installation Manual

Disconnect the light by pressing down on the
connector. Repeat steps 5-7 for passenger side tail
light.
Clean all dirt and debris from vehicle then use
supplied alcohol wipe where part will be. NOTE:
Temperature should be at least 60°F for proper tape
adhesion.
Slide light toward the inside of the vehicle then pull
out to remove the tail light.
76
6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX [phone]
Rear Corners Installation Procedures (Passenger Side)
Using masking tape, tape each tab on the outside of
the part as shown.
Position part on vehicle and using a #2 Phillips
screwdriver, loosely start screws in the two locations
they were removed from in the tail light.
Slide covers off door hinges.
9
1110
Using a marker, label the tape tabs with the numbers
1-10 as shown.
8
1
1
2
2
33
7
7
4
4
6
6
8
8
9
9
10
10
5
5