Installation Manual

6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX [phone]
Vehicle Preparation Procedures (Driver Side)
Using a #2 Phillips screwdriver, remove two screws
closest to the inside of the vehicle.
Using a 7mm socket with a 1/4” ratchet and 1/4”
extension, remove two bolts from the face side of
the license plate frame.
Pull license plate frame away from vehicle and
disconnect the frame by using a small screw driver
or similar tool inserted in the hole and pressing down
on the connector to pop it out.
5
3
4
Remove license plate, then using a 7mm socket with
a 1/4” ratchet and 1/4” extension, remove two bolts
from the bottom of the license plate frame.
2
Removing Hard Top
Using a T-40 Torx bit and a 3/8” ratchet remove six
bolts fastening hard top to vehicle (3 bolts per side)
and save bolts for reinstallation. With a partner,
remove hard top from vehicle.
1