Installation Manual

TOOLS FOR EASY INSTALLATION

• #2 Phillips Drive bit

• T15 Torx Bit

• T30 Torx Bit

• Utility Knife

STEP 1.

Prior to Installation:

A) Bushwacker only approves installing the flares according to these

written instructions with the hardware provided. WARNING: Failure

to install according to these instructions will invalidate the warranty.

This includes, but is not limited to using alternative installation

methods, hardware, or materials. DO NOT USE: Loctite,

SuperGlue, or similar products on the hardware or the flares.

Fit: Verify you have ordered the correct Body Cladding for your

vehicle make and model and check their fit.

Painting : (Optional) if paint is desired it must be done prior to

installing flares on the vehicle clean outer surface with a good

grade degreaser. DO NOT USE LACQUER THINNER OR

ENAMEL REDUCER AS A DEGREASER. Wipe outer surface

thoroughly with a tack rag prior to paint.

Paint flares using a high quality enamel, or polyurethane

automotive paint. (Application of a primer coat is optional)

Kit Supplied Hardware:

INSTALLATION PROCEDURES

IMPORTANT NOTE: Ambient Temperature – During installation: the vehicle, the parts, and the tape

need to be between 60° and 110°F for proper adhesion. Vehicle surface must also be wiped with alcohol

to remove dirt and grease, which may also affect adhesion. Failure to maintain proper installation

temperature and surface preparation may result in the part not functioning correctly.

STEP 2: Preparing Work Area

A) Remove the front marker lights as shown in Photo #1.

B) If you are installing the front corners with Bushwacker

Fender Flares, loosen the first three bolts in the fender

flare, but do NOT remove. See Photo #2.

C) If you are installing the front corners with OE Fender

Flares, you do not need to loosen the flares.

Jeep TJ TrailArmor

Front Corners and Hood Protector

Set Part # 14005

Rev 1 01/08/10

Plastite Screw

(4 per)

6710 N. CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX 503-283-3007

Photo #1 – Front Marker Light Cover Removed

PAGE 1
Jeep TJ TrailArmor Front Corners and Hood Protector Set Part # 14005 Rev 1 01/08/10 STEP 1. Prior to Installation: A) Bushwacker only approves installing the flares according to these written instructions with the hardware provided. WARNING: Failure to install according to these instructions will invalidate the warranty. This includes, but is not limited to using alternative installation methods, hardware, or materials. DO NOT USE: Loctite, SuperGlue, or similar products on the hardware or the flares.
PAGE 2
STEP 3: Front Corner Installation A) Peel red vinyl backing from the tape on the Front Corners. B) For Bushwacker Fender Flares: Slide the edge of the Front Corner between the fender flare edge trim and the body. C) For OE Fender Flares: the Front Corner edge will be positioned over the flare. D) Using the holes in the Front Corner tabs as a guide, align with the two (2) factory marker light holes as shown in Photo #3.