Owners manual

Peel red liner partially from tape pads. NOTE: Make
sure tabs are folded toward the outside of the part
and that the middle tape liner is in front of rear liner.
Press the part into place starting at the left side,
pushing downward and forward while working your
way to the right. Apply 30 PSI to the taped areas
for proper bond. Tape reached maximum adhesive
bond after 24 hours of contact.
Maintaining part placement, stick peeled end to
bumper and pull tab nearest the rear of the vehicle
while applying downward pressure to rear edge of
part. Repeat process for liner for center tape, then
liner towards the front of the vehicle.
Make sure that all installation surfaces are free of
dirt and/or grease. Use a clean, lint-free cloth and
isopropyl alcohol-based cleaner.
When peeling liner along front edge of part, run edge
trim tool along under part in front of liner to create a
small gap for ease of liner removal.
Hold the part at an angle to prevent tape from
prematurely sticking, and align the part on the
bumper by aligning center rib in part with metal loop
on striker and using the masking tape applied in
Step 2 as a guide.
4
8
6
3
7
5
4325 HAMILTON MILL RD • BUFORD, GA 30518 • 800-241-7219 (USA AND CANADA) • FAX [phone]
2