Product Manual

| Safety Flag
Page 2
Meets Regulations
• National Parks South Australia compliant for use in the
Simpson Desert Conservation Park and
Regional Reserve.
• CAMS compliant
• Most mine sites compliant (Check local regulations
before using product)
Please check all relevant motoring standards for compliance
and mounting requirements.
To take full advantage of this product, please read this manual carefully before using.
Retain this manual for future reference for installation and warranty.
Safety Precautions
• Ensure all fasteners are tightened to the
correct torque.
• Regularly check that all fasteners are correctly
tightened. It is highly recommended to check more
frequently when travelling on rough roads.
• Always check local regulations before using this
product to ensure ag size, height and colour
are satisfactory.
• Ensure vehicle mounting location is strong enough
for tting your safety ag.
• Always remove your safety ag when driving faster
than the rated maximum speed.
Male Pole Joiner
Rubber Washer
Female Pole Joiner
Male Base Pole
Female Base Connector
D Ring
Male Base Connector
Spring Washer
Nut (Torque 80Nm)
Vehicle Bulbar/Aerial Mount
Caring For Your Product
• Use a non abrasive bre brush or sponge with mild
pH neutral soapy water to wash the
Safety Flag material.
• Rinse thoroughly after cleaning.
• Always rinse your Safety Flag and ttings
thoroughly in fresh water when using in a corrosive
environment like beach driving.
• Ensure the Bushranger Safety Flag is completely dry
before packing away.
Specications
Overall Size:
Pole Material:
Flag Size:
3m | 3 sections 1m
Solid Fibreglass
300mm x 290mm
MAXIMUM SPEED RATED TO 30km/h
Always remove ag when exceeding this speed