Product Manual
• When winching, always use a recovery damper.
Place over the rope in the middle third of its
length.
• A rope should be replaced if it shows signs of
excessive wear, broken strands, corrosion for
wire rope and excessive abrasion or fused and
melted bre for synthetic rope or any
other defects.
• If the winch fails to pull a load under normal
conditions, manually stop the operation,
otherwise motor damage may occur.
• Check that the clutch handle is in the
“Engaged” position during and after use.
• Remove the remote control from the winch
when not in use and store in a safe, dry place.
• Do not wrap the rope around the load and
back onto itself. Always use a tree trunk or
winch extension strap.
• Keep hands and clothing clear of the winch,
rope, and fairlead opening.
• Never unplug the remote control when
winching a load.
• To avoid insufcient power when winching a
load, the vehicle should be running and
in neutral.
• Keep the remote control clear of the rope at
all times.
• If noise or vibration occurs when operating, stop
the winch immediately and inspect or return it
for repair.
• The rope must be wound in an under-wound
orientation only to ensure correct
brake operation.
• Always inspect the hook, latch and pin prior to
use. Do not use if there are any signs of excess
distortion or bending.
• Ensure the pin of the hook is secured using a
correctly installed split/cotter pin.
Fleet AngleRope
Centreline of anchor point
WRONG FITMENT
CORRECT FITMENT
Overwound
Underwound
Installation
It is highly recommended that installation is performed by an authorised
technician, familiar with this product.
The winch is provided with a range of bolts to suit the different mounting options:
Note: Four (4) M10 x 1.50 pitch 8.8 grade high tensile steel bolts (supplied) must be
used in order to sustain the loads imposed on the winch mounting.
Winch mounting
• It is very important that the winch is mounted on a at and hard surface or
mounting channel or in a suitable winch-compatible bull bar to ensure the motor,
drum and gearbox housing are aligned correctly.
• The fairlead is not designed to mount to the winch directly.
• The rope must be wound in an under-wound orientation only.
• 4 x M10x35mm Hex Head bolts (for foot down installation)
• 2 x M10x50mm Button Head Bolts (for mounting Hawse Fairlead in foot forward
mounting – REVO 10S and 12S)
• 2 x M10x45mm Button Head Bolts (for mounting Roller Fairlead in foot forward
mounting – REVO 10W only)
• 2 x M10x40mm Button Head Bolts (for mounting Hawse & Roller Fairlead in foot
down mounting)
• 6 x M10 Spring Washers
• 6 x M10 Flat Washers
• 4 x M10 Hex Nuts
• 2 x M10 Lock Nuts
Foot Down Installation Foot Forward Installation
Torque Settings (Maximum)
M10 x 1.5 – 8.8 Grade 44 N.m
| REVO VEHICLE RECOVERY WINCH |REVO VEHICLE RECOVERY WINCH
Page 3 Page 4