Product Manual

| X JACK Guidelines
Page 3
STEP 4: Lifting Operation (No Person(s) Shall Remain in Vehicle)
STEP 5: Lowering Operation
STEP 6: Inspection
Safety & Care Information
Safety & Inspection
Care & Maintenance
Make sure vehicle’s gearbox is in neutral or park and start vehicle’s engine and allow to idle.
OPTION A - Air Compressor: Inate XJack by connecting an air line to the compressor adapter inlet – Do NOT leave unattended.
OPTION B - Vehicle Exhaust: Firmly press rubber cone end of hose over vehicle’s exhaust pipe end, making sure the hose has no
kinks.
When X JACK is partially inated (just touching vehicle) turn off air compressor/engine and ensure the X JACK is squarely in
position and clear of sharp edges and hot areas. Check to see if protective mats are correctly positioned –
See Note 1 below.
Restart air compressor/engine and continue to inate X JACK until wheel is clear off the ground, then turn off air
compressor/engine. Do NOT inate beyond required height or exceed 68.9 kPa (10psi) – X JACK does NOT need to be fully
inated for recovery.
It is important to lower the vehicle by slowly turning the hose anti-clockwise to deate X JACK. Ensure not to deate too
quickly or it will cause a rapid deation of the X JACK resulting in an uncontrolled lowering of the vehicle.
Note 1: If X JACK does not achieve an upright position or is not positioned correctly during ination process, stop operation.
Deate X JACK – see Step 5 Lowering Operation then repeat Step 4 after realigning X JACK.
Note 2: If the X JACK does not inate, check the exhaust system for leaks.
Note 3: Do NOT over inate. If X JACK reaches full ination (i.e. 10psi) or stoped lifting the vehicle, STOP operation.
Note: DO NOT get under a raised vehicle.
Note: Ensure all body parts are kept clear of vehicle whilst deating.
If the X JACK exhibits any of the above discard the X JACK.
After recovery, ensure vehicle is stationary and secure. Remove recovery equipment.
Inspect X JACK for damage before packing. If damage noted, please do not use. Contact our ofce on the number stated
below for further advice.
• Ensure X JACK is not stored in direct sunlight or wet / humid environments.
• Do not expose X JACK to any petroleum-based products, acids or alkaline products
• Clean X JACK in warm water and allow to dry in the shade. (Always ensure X JACK is dry prior to being stored).
• Always inate and deate the X JACK several times after purchase to prolong the life of the X JACK.
• Always inate and deate the X JACK several times at 3 months intervals when it has not been inated. Inating and
deating the X JACK regularly not only prolongs the life of the X JACK, it also allows you to familiarise yourself with the
X JACK and its functions.
• Evidence of heavy impacts
• Cuts and abrasions
• Badly worn
• Seam weld damage
• Deformation
Prior to using the X JACK or any of its components inspect for damage. Damage may include:
Please follow all points - Failure to do so will void the warranty.