Quick Start Guide

4
Fig. 6
Fig. 7
8
• You can use the five icons (and up to 20 numbers)
to mark different locations of any kind (your truck,
treestand, a campsite, etc.). Be sure you select a
differenticonor # to storeeach new location.If you
hold down MARK with a previously used location
iconstillselected,youwillreplacethatonewithyour
currentlocation.
• Toexpand or restrictthe number of“extra”locations
(numbersfrom1to20)thatareavailable,PressSETUP
(4)threetimesuntil the locationarrowonthe lower
right is highlighted. Press MARK(2), then use the
TRIP/DATAorSETUPbuttonstodecreaseorincrease
thenumberbelowthearrow(Fig. 6).PresstheMARK
buttontoconfirmandreturntotheSetupscreen.
AUTO POWER OFF/BACKLIGHT
• Power automatically turns off after 10 minutes if no
buttons have been pressed (except in Trip mode,
described next). HOLD POWER to turn the unit off
manually.
• Pressthe MARKbuttontoturnthedisplaybacklight
on.Itautomaticallyturnsoffafter30seconds.
COMPASS CALIBRATION
• To ensure directional accuracy, hold the HuntTrack
outinfrontofyouandmoveitina“Figure8”pattern
a few times to re-calibrate the compass (Fig. 7). A
compasscalibrationvideoisavailableat:http://www.
bushnell.com/products/gps/instruction-videos/.
• For best results, we recommend holding the
HuntTrack inahorizontalposition(nottilted)during
use(Fig. 8).
Fig. 8