Operation Manual
Congratulations on your purchase of a Bushnell ImageView binocular. Before using the product, please 
read these instructions and take time to familiarize yourelf with the different parts and features of the 
product.
BINOCULAR INSTRUCTIONS   
TURNING  THE  CAMERA  ON 
AND 
OFF
Insert  2  AAA  alkaline  batteries  as 
indicated  on  the  inside  lid  of  the 
battery compartment, located at the 
side of the  left  eyepiece.  Turn the 
camera  on  by  pressing  and  holding 
the  MODE/PO
WER(      )  button 
until  the  display  comes  on  and  the 
camera  beeps.  To  turn  the  unit 
off,  press  and  hold  the  MODE/
POWER(  ) button until the display 
goes 
out. The camera will turn itself 
off  automatically  to  save  batteries 
if  none  of  the  buttons  have  been 
pressed for three minutes.
1
SNAP 
(Shutter Release)
OK
MODE / POWER (On/Off)
TAKE A PHOTO (TIPS FOR BETTER QUALITY PHOTOS)
With the camera turned on, press the SNAP button to take a new photo. For best 
results, hold the ImageView steady using both hands, and lightly press down the SNAP 
button using the flat end of your finger rather than “punching” it with a fingertip. For 
normal photos of distant objects over 25 feet (8 meters) away, leave the 2-position focus switch at the 
front of the camera on the “mountain” icon (left position). If you need to take photos of closer objects, 
set the focus switch to the “flower” icon (right position). This will change the camera focus to a range 
from approx. 10 to 25 feet (3-8 meters). Be sure the focus switch is set back to the normal (mountain) 
setting when you are no longer taking close range photos. 
USING THE IMAGEVIEW WITH YOUR COMPUTER
BEFORE CONNECTING THE IMAGEVIEW TO A COMPUTER, first install the driver from the 
CD-ROM as directed  in “Software  Installation”.  After the driver  has been installed,  you may install 
Roxio“ PhotoSuite 5 as well, following the on-screen instructions (if you do not already have photo 
software you prefer to use). Connect the supplied USB cable between the ImageView and your computer, 
using  a USB port on the computer  itself  (avoid  “hubs”).  Please  read  “Downloading  Photos to  Your 
Computer” for detailed instructions on transferring photos to a PC using PhotoSuite. 
11-0718 6LIM.indd 6-7 7/19/04 8:50:24 AM










