Manual

46
TROUBLESHOOTING…
PROBLEM
WON'T FIRE
CHECK FOR:
Selector Lever on SAFE
Improper assembly of
Firing Pin.
Too much oil in Firing
Pin recess.
Defective Ammunition
Too much carbon on
Firing Pin or in Firing Pin
recess.
WHAT TO DO
Put it on FIRE
Assemble correctly.
RETAINING PIN GOES IN BACK OF LARGE
SHOULDER ON FIRING PIN.
Wipe out with pipe cleaner.
Remove and discard.
Clean.
45
BULLET STUCK IN THE BORE…
1. Remove the Magazine
2. Lock the Bolt
to the rear.
3. Place the
Selector Lever
on SAFE
4. Check for a
Bullet in the Bore
WARNING: If an audible “POP” or reduced RECOIL is experienced during firing,
immediately CEASE FIRE: Then, (1) Remove the Magazine, (2) Lock the Bolt to the rear,
(3) Place the Selector Lever on the SAFE position and (4) visually inspect and/or insert a
cleaning rod into the bore to ensure there is not a bullet stuck in the bore.
IF A BULLET IS STUCK IN THE BARREL OF THE WEAPON, DO NOT TRY TO REMOVE IT.
TAKE THE RIFLE TO A QUALIFIED GUNSMITH.
DO NOT APPLY THE “IMMEDIATE ACTIONS” PREVIOUSLY DESCRIBED ON PAGE 43.