Manual

28
MAGAZINE DISASSEMBLY / REASSEMBLY …
1.) Release Base Catch by
prying up gently on the
Magazine Floor Plate
(just enough to clear).
3.) Jiggle Spring and Follower to remove. Do
not remove the Follower from the Spring.
TO CLEAN and LUBRICATE, Wipe dirt from
Magazine Body, Spring, and Follower. Then
lightly lubricate the Spring.
REASSEMBLY is reverse of steps above.
Make sure to slide the base under all four
tabs until it snaps back under the catch.
2.) Remove Magazine Floor Plate by sliding
it out of the Magazine Body.
27
REASSEMBLY (continued)…
14.) Close the Upper and Lower Receiver groups and push
in the Takedown Pin.
17.) Re-attach the Sling.
When re-attaching the Handguards, use
The “Buddy System”:
15.) Place the Rifle on the
Buttstock and press down on
the Slip Ring with both hands.
Note: The “Half-Round”
Handguards are identical and
can be used on top or bottom.
16.) Have your buddy install one
handguard on top and the
other on the bottom.