Manual

23
REASSEMBLY (continued)…
3.) Push in Extractor Pin.
4.) Slide Bolt into Carrier.
STAGGER THE GAS RING GAPS
TO REDUCE GAS LOSS. Position the three
ring gaps 120 apart around the bolt.
24
REASSEMBLY (continued)…
5.) Replace Bolt Cam Pin.
GIVE
CAM PIN
A 1/4 TURN
AFTER
INSERTION
6.) Drop in and seat
the Firing Pin.
FIRING PIN
7.) Pull Bolt out.
WARNING: Be sure the Cam Pin is installed in the Bolt Group. If it isn't, your rifle can still fire
and will explode!
NOTE: The Bolt is machined so as to allow insertion of the Cam Pin from one side only. This
provision aligns the Extractor and Ejector properly within the Upper Receiver.