Instruction Manual

Pg. 61
Bush master Carbon 15 Models – Differences…Bush master Carbon 15 Models – Differences… (Continued)
Carbon 15 Upper & Lower Receivers: Beside the fact that they are molded
Carbon Fiber material, the Upper and Lower Receivers on Carbon 15 Rifles and Pistols in the
“R” or “P” Series Models separate from each other in a different
manner than XM15 E2S Bushmaster models with Aluminum
Receivers. The disassembly steps are:
1. Weapon should be in a SAFE CONDITION. Clear Rifle (or
Pistol) and remove Magazine. Make sure Bolt Carrier is
fully forward and locked.
2. Push both Takedown and Pivot Pins out from left side of
Lower Receiver.
3. Grasping the Lower by the Pistol grip and the Upper by the
Forend as shown, tilt the front end of the Upper so that
Pivot Pin Lug clears the Lower Receiver.
4. This will allow you to move the Upper forward - separating
it from the Lower - while at the same time releasing the
Buffer and the Action Spring from the Buffer Tube. Use
Caution as the Action Spring will be under some tension.
5. Reassembly is the reverse of these steps.
These instructions apply specifically to these Models:
R97S Rifle (AZ-C15R97S)
R97 Rifle (AZ-C15R97)
R21 Rifle (AZ-C15R21)
“Lady” Rifle (AZ-C15R21C)
NOTE:
P97S Pistol
(AZ-C15P97S)
P21S Pistol (AZ-C15P21S)
P97 Pistol (AZ-C15P97)
P21 Pistol (AZ-C15P21)
Bushmaster Carbon 15 Models – Differences…
0_Placed.qxd 12/28/07 3:30 PM Page 61