Instruction Manual

Most Mil. Spec. design M-16 / AR-15 type Magazines can be
disassembled for cleaning. The Magazine Spring, Magazine Follower
and Magazine Baseplate can be replaced if broken or excessively worn.
1.
To disassemble Magazine, pry up on bottom of Baseplate using
Bullet Tip or Punch, and push indentations in Baseplate past
Magazine Body
2. Slide Baseplate out of Magazine Body.
TO CLEAN
and LUBRICATE:
Wipe all
dirt from the
Magazine Body, Spring, Baseplate and Follower.
Then lightly lubricate the Spring.
REASSEMBLY is the
REVERSE of these steps. Make
sure to slide the base under all four tabs until it
snaps back under the catch.
NOTE:
Do not remove Follower from Spring.
3.
Jiggle Magazine Spring and Follower out of Body.
Pg. 43
MAGAZINE DISASSEMBLY / REASSEMBLY…MAGAZINE DISASSEMBLY / REASSEMBLY…
PROBLEMS / SOLUTIONS…
0_Placed.qxd 12/28/07 3:30 PM Page 43